Question about Heating & Cooling
...furnace inducer motor wont start hear a siziling sound pryor the code read 3.1 furnace wont turn on just a siziling sound Make sure there is power to the inducer motor...if it is a PSC motor, check ...
Question about Heating & Cooling
...furnace (from what ive read i guess thats the draft inducer motor). that motor gets hot to the touch. the pilot do thanks for any suggestions, hurricane sandy is on its way Sounds like a bad induced ...
...furnace. When there is a call for heat a relay closes to start the inducer the movement of air causes by the inducer closes the air pressure switch. This is where the problem starts.some where in the ...
furnace will start normal and run for a few min, then the burners will kick off but the inducer motor and blower motor will continue to run. About 1 min later the burners will relight and furnace will
Question about Heating & Cooling
...furnace and still the blower motor and IDM motor both start,Does this mean the control pcb is bad? NO BECAUSE THE BOARD IS TELLING THE FANS TO STARTARE THE CONTACTS FUSED TOGETHER OR STUCK IN THE ...
...furnace is usually: 1: Inducer draft motor comes on 2: Hot surface ignitor comes on and glows 3: Gas valve opens, lights burners 4: Flame sensor detects flames 5: Blower comes on If the inducer motor ...
...furnace runs then you have a problem with the vent system The tubing that connects the induced draft proving switch (a pressure switch) to the induced draft assembly so it may "sense" the induced ...
...furnace. It will go thru a purge cycle first. The draft inducer motor will run to do this. After the purge the hot surface igniter should get hot a glow, then the gas valve will open and the burner ...
Question about Goodman Heating & Cooling
...furnace GMP075-3 The thermostat was in the off position over night and sometime during the night, the induced blower and blower motor came on. The trouble light on board blinks 5 times. I checked all ...
Question about Heating & Cooling
...furnace. The basic sequence is: 1. thermostat calls for heat 2. inducer motor starts and runs for a pre-set amount of time 3. the pressure switch closes and allows for ignition trial 4. ignition is ...
43 questions posted
Usually answered in minutes!
1,056 Questions
416 Questions
195 Questions
147 Questions
138 Questions