immediately goes back off. I did the test, holding the menu and inout and it does bkink 2 then 2. Any suggestions? You need to replace one STK393-110 and 2 or more 5amp pico fuses. Very common problem
...test the value of the low ohm resistors that feed those amps. In this case, blue being bad, my guess is you'll find R8c21 & R8c22 (3.9 ohm 1 watt) changed in value or nearly wide open. But check all ...
...test the value of the low ohm resistors that feed those amps. In this case, blue being bad, my guess is you'll find R8c21 & R8c22 (3.9 ohm 1 watt) changed in value or nearly wide open. But check all ...
...Stk393-110 Mits. Part # 267p155010 and the fuse 9a04... On a scale of 1 to 10 and 10 being the most difficult the task is about an 8 to replace and trace test the convergence circuit. You can however ...
Question about Mitsubishi Televison & Video
...STK393-110 is the IC that in your set. You are going to need two of them and thermal grease that has to be applied to the ICs before soldering them to the board.Should cost you about 15$ per pair ...
...test by holding down, I think, menu and device for 5 seconds and got error code 23. But when it was on, I could get a glimpse of the static screen (snow) and could see convergence issues. What I saw ...
Question about Mitsubishi Televison & Video
...test the various components in the Horizontal deflection circuit and help you get your set up and running again. I replaced STK393-110 and after I had unsoldered it and was removing it, some of the ...
...STK393-110.html. The reason I recommend this distributor, I have ordered many of IC?s, a lot for a lot less money, but they are not original Sanyo IC?s. Yes, these IC?s in this Mitsubishi set is made ...
175 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions