...put new points and condensor in...one time i put a cheap-o set of points in a 1949 Ferguson..and they lasted 4 months..so i spent a little extra and got a heavy duty set..and havent had a problem ...
put on a new 12 coil changed points and condersor was runing before i burned out 6 v coil check the resistor mounted on the back side of the dash, resistor dead no spark. you can strap it with wire to
...put new plugs in and have fresh fuel any suggestions check for sprak take one plug and put one of the wires on the plug, lay it on the block. make sure its on metal. turn over you shpuld see spark if ...
Question about John Deere Garden
...put a new spark plug and a new coil still no spark Make sure you set the gap properly on the coil should be a filler gauge 10. Make sure the flywheel is clean at the firing point. And make sure there ...
...deere 140. I'm not getting any spark I have a john deere 140. I'm not getting any spark I put a new coil and new spark plug and wire. I do you have power to the coil. check the points and ...
Put in old plugs to verify new plugs...aren't faulty. Drain old gas from tank and carb completely! Water doesn't combust!!! Drain drain drain! No addictive a, no make shift remedies... Just drain tank
...Remove 2 screws, remove coil. When you assemble new coil, put in 2 screws loose then put a business card in between coil and magnet tighten screws then spin flywheel to get card out and you are
...of those engine lose there timming gears,Im sure it can happen,but very few,your fireing order is 1 2 4 3,I hope this helps you my 2n will runut will i put new points in it almost start it try to run ...
...new points plugs condenser, started right up went out the next morning wont fire but turns over . agin no spark Clean the points with an emery board if this doesn't fix it roll the motor until the ...
165 questions posted
Usually answered in minutes!
1,057 Questions
111 Questions
134 Questions
149 Questions
88 Questions