Toshiba 1360 Black and White Copier "roller fuser red" Questions

...in the fuser roller. Change the fuser unit if you have to hand. The problem is likely caused by a lack of pressure from the pressure roller. Also check the transfer roller for a similar ghost

in richo 1045, paper is contineus jam in the upper side of fixing unit Clean oe change the upper fuser roller,fuser roller cleaning roller and clean the lower pressure(red) roller.

roller, then the clip has broken. If the fuser does not heat at all, then you have either a bad low voltage power supply, a blown fuse, or burned out quartz lamp (goes through the center of the teflon

...fuser roller in the fuser unit is damaged. Do i need to replace the whole unit or can just the roller be replaced. If so, where can one be purchased. I have found sources for the whole unit, just not ...

...out. It sounds like the fuser roller is not turning. Remove two small caps, unscrew the fuser fuser and remove it. Rough up the red roller with Scotch Brite Oil the black bearings on the top

...of small rubber exit rollers, this switch (between middle and left) can get damaged it also likely that a piece of paper is concertinaed in fuser. pic of rear of fuser and exit switch in red ...

...fuser roller will show up on your printed pages. If you do need a new fuser you can find them for $160, or the entire rebuild maintenance kit for $375 ...

...areas. Check all doors are shut. pic of rear of fuser and exit switch in red circle thanks so much. it worked!!! this solution should be posted in the regular instructions!!!!!! you were most

...and cartridge compartment or EXIT: Between fuser and EXIT UNIT. ALSO could be BAD SEPARATION ROLLER IN THE PAPER CASSETTE TRAY and UPPER SEPARATION ROLLER OR BROKEN FUSER. Question? call ...

...fuser unit the fuser unit (red rubber roller) is old and falling apart, therfore, the paper coms out blury and wrinkeld. Precision Roller Printer Toner Cartridges Parts and Supplies Office... try ...