...fault is definitely the SR7300 Amp. A couple of techo taps on top of unit fixes the fault temporarily. There is Definately a Short in the Amp if tapping Fixes it. Could try opening the amp and ...
Question about Kenwood Audio Players & Recorders
...amp sinks get hot reguardless of volume setting? heat in amps =power or fault, since you have no power then its most likely the fault that is causing the heat, I would take it to my dealer or a good ...
...amp is not strong enough for the speakers, or there is a fault condition where the output stage is pulling too much power, and the protection circuit is kicking in, because of one of these faults. It ...
...just need turning off and then on again when the fault has gone. if its not then you may still have a fault maybe bad speaker or a short something like that. if not then the amp itself may be
...fault. It can be inside the amp or outside to connections to speaker. If it cliks and shuts off/stanby, protection circuit inside it has the fault and should be rectified. To look into that section, ...
Question about Yamaha Audio Players & Recorders
...amp does not go into the second stage of powering up indicates a fault which is causing it to sit in non-active mode. This could be due to blown output audio module or transistors or a fault in ...
...Speakers, Surround Speakers[L&R] and Front speakers[L&R]. Which amoung this show fault? Please clarify more about your Amps' problem. Include the details of fault by FixYa comment box.
Question about Yamaha Audio Players & Recorders
...everywhere. When you can make it stop working at will by jiggling something, you've found your fault. The only other possibility that springs to mind is a fault inside that channel in the
...fault is removed. In this case, you should remove both inputs and output (speaker) and power it up. If the amp doesn't light any protection lights or indicators, then turn it off and connect a known ...
...amp making that horrible sound and says protect? It is not so easy to probe into to find a protection fault condition. The fault can be your output drivers- the MOSFETS/IC's fitted for both the ...
49 questions posted
Usually answered in minutes!
269 Questions
261 Questions
161 Questions
135 Questions
85 Questions