Optoma H56 Multimedia Projector "clean fan" Questions

...the device overheated. If fan is working the air filter might need to be cleaned. See you manual how to clean filter and reset the filter cleaning counter so that the device can work properly

...fan to clean it, then have someone hold the projector up, so the hole faces down..and the dust will fall that way as well instead of back into the projector. select quiet mode in the menu under ...

...fan for the lamp, out, clean it really good, try to get every little bit of dust ,that you can see ,then you wont have any more problems of overheating,until more dust builds up,then youll know what ...

...clean your fan's. there are 2 fan's insinde the HD70. probably the most problems will be solved by cleening the color wheel!! if the problem is not solved ,chack the lemp and the fans if they work ...

...clean. Both fans are working. I put an outside fan just blowing on the projector with it open and it runs for an easy 30 minutes. I haven't tried it past that point. I take the outside fan off and it ...

...clean what else would cause this fault? hi, check , is the fan is working or not. a fan is used for cooling the lamp,( through out till it is on.) if the fan is not working the lamp will get over ...

...clean the fan filter? Filter will be located near the intake fan. You can remove it and clean it. Normally just blow out the dust. If it is oily you can use dish soap be sure it is fully dried before ...

...fan and must be cleaned and reset. So remove the filter and clean , check for dirt or obstruction. Check the free flow of the fan to the lamp, if the fan is faulty or not running to the desired speed ...

Very noisy fan, what to do? take the fan out( you have to dismantle projector) clean it out and put some grease in the bearings of the fan. OR else just get a new fan on ebay.