Kenmore Elite 45986 Front Load Washer "shallow pump impeller removal" Questions

...shallow pan and lay a piece of towel under the pump filter prior to the removal of the filter. Turn the filter knob counterclockwise to remove and clean it. Reach in the pump to check if it is ...

...pump is replaced. f02 means that the water is not drained out after 8 minutes of drain.After removing bottom front plate,you will observe a white filter cap,by removing this cap,you can clean out the ...

...pump and drain the remaining water from the tub drain hose into a shallow pan. Lay the machine on its side on a cushioned surface to allow easy access and removal of the drive belt. Remove the three ...

shallow basin or the likes. Once drained, lay a piece of towel under the filter then turn the filter knob counterclockwise and remove it. Clean the filter and reach in the pump impeller to check it if

...shallow pan and remove the end plug to drain the remaining water out of the machine. If water does not come out, the hose may be plugged with sand. In that case, pull the washer about 18 inches or so ...

shallow dish under the filter. Loosen the filter to drain out the water. Remove the filter and clean it out. Look at where you removed the filter and you will see the water pump impeller. Make sure it

...shallow pan. Remove the sump hose from the tub by loosening the clamp holding it. Remove the drain hose from the drain pump and the recirculation hose from the recirculation pump if there's any. ...

...pump filter screen...Get a shallow pan to put under screen. Turn lid counter clockwise to remove(turn slowly and allow water to drain. As you may need to dump pan several times before all water is ...

...shallow basin to drain the water. Position the bucket or basin as low as possible to extract as much water from the tub. Completely drain water from the tub through the pump filter cavity. Remove the ...