Brother CS-6000 "needle hitting plate" Questions

needle is hitting the sides of the needle plate where the needle goes through, then the needle is too wide for the plate. Either use a narrower twin needle or see is a needle plate with a wider needle

...capability allow you to adjust the position of your needle ? right,left, or center. If your needle is not positioned correctly, it may be hitting your needle plate or pressure foot. I hope this

...needle is hitting the bobbin plate. Can't figure needle setting. The needle keeps hitting the bobbin plate. first change the needle--flat side to the back of the machine, make sure the needle ...

...needle is hitting the lower looper, and therefore breaking. This is happening with both needles. I have taken the covers off and the needles are hitting the metal. Is it possible that the looper has ...

...needle hits, if you are in zig-zag mode and it is hitting the base plate(wide slotted base plate req'd) the machine may need re-setting of the needle stops(if fitted). This is uncommon so its more ...

...capability allow you to adjust the position of your needle ? right, left, or center. If your needle is not positioned correctly, it may be hitting your needle plate or pressure foot. Hope this

Needle hits the plate and bends. What would cause this? The machine seemed to work fine before, but now the needle hits the plate when sewing. I'm assuming something is causing the needle to ...

plate The needle misses the hold where it should go through and hits metal one the throat plate. I fixed the sewing problem, it was a belt. if a new needle still wont align with the needle plate, your

...needle keeps hitting the throatplate, (I have broken 2). It was working fine. I don't know what I have done to cause this! e. Hello, First, check the position of your needle.Machines with zigzag ...

...the mount so that it is straight up and down. If the needle is still hitting the plate, the needle bar may be bent. That may be not be repairable even by a professional. I hope this helps. Cindy ...