Baby Lock Imagine "sewing machine looping reverse" Questions

reverse & cannot be corrected by upper tension dial . machine has done this on & off since bought last year Check the tension on the bobbin in the base - there is a small screw on the bobbin that sets

sewing machine jammed with the needle bar at its lowest point, open the bobbin cover. If you see a loop of thread, try and slide that loop until it clears. If there are several loops around the bobbin

...sewing machine make sure the foot is 'up' as this opens the tension disks and the thread goes between. when you lower the foot the discs close around the thread and add the tension. Hope this helps ...

sewing machine not working in reverse I have cleaned the feed-dogs and oiled the machine. When I leave the thread out of the needle, the machine works fine in reverse. When I thread the needle, the ...

sewing machine. Backstitching: fine. Straight stitching: fine. On the occasion when I stitched one stitch too far and need to manually reverse a stitch, I get a mess of loops from the bobbin thread on

...machine, cleaned dust from bobbin section, put in new needle, thread and bobbin. It worked well before. I have read manual for troubleshooting and can't figure it out. Zigzag and knit stitches are a ...

Looping of stitching on the reverse of the material. The top stitching is fine but when I look at the reverse it is horribly looped. What am I doing wrong? I have been given this Singer 358 and it has

...reverse hook; from say, singer; over time your hook has slipped and is barely looping the thread: adjust your hook to enter the thread loop about 1/4" before the needle raises to make the stich then ...

Im left handed How do I make a crocheted loop stitch ? My niece many years ago made her daughter a crocheted loop stitch little jacket. She tried to show me, but Im left handed. Can you help me? Have ...

...sewing machine out of the box a few hours ago to have a tinker.. I was trying out some of the embroidery presets, which all turned out lovely.. after a while I noticed that the machine had started ...