bottom thread in your stitching looping and knotting. If yes to 1. you need to rewind your bobbin fresh, and keep slight tension on the thread reel that you are winding it from. Put the handle of your
...right and when I sew it knots up on the bottom side of the stitech the knots on the bottom are caused by the top thread not being in the tension disc or something in the discs( thread , fuss
Question about Sewing Machines
...thread and bottom thread are not properly contacted or do not interact correctly. Whenever knotting happens, you will notice that thread will bunch underneath the fabric. You can try re-threading the ...
bottom thread tangles and knots I have a Toyota CU17 but no manual. why is the underside thread knotting and tangling? usually a top-thread tension issue, try tightening up the top thread's tension, ...
...MACHINE WHY THE BOTTOM THREAD KNOTS WHILE SEWING Check your tension on the bottom thread, it should not free run, should have some tension on it to keep it from over feeding which lets it knot
Question about Singer Sewing Machines
...bottom tension on this as it keeps knotting up? Athena MODEL If your top thread is knotting up in bobbin area, your top thread is mis-threaded, possibly out of take-up lever or tension disks need ...
Question about Consew Sewing Machines
...bottom. I have changed the needle and the top stitch is perfect. Please advise. Re-check the thread that is knotted. It's most likely the top thread causing what is called thread nesting or what I ...
thread just knots into a huge ball on bottom of fabric...everything is threaded correctly and all tension set well...next step is trash can! Recheck the top thread and bobbin tension for equal balance
...and had a horrible time getting it off machine but did and put on another needle - now machine knots the bottom thread every 4 or 5 inches? Owner's manual, No manual? try
...knotted up thread under the material indicates that the needle thread tension is incorrect ( needs tightening) once you have that correct the material, will feed normally use scrap when adjusting and ...
217 questions posted
Usually answered in minutes!
64 Questions
435 Questions
168 Questions
144 Questions