...trimmer motor runs but blades do not move Had the same problem: when I turn on the trimmer, the motor would hum but the blades won't move. What I did: 1. Sprayed a ton of wd40 between the blades 2. ...
...trimmer worked just fine last time I used it but I took it out yesterday and the blades don't move. The motor runs and the blades act like they want to go, but they're frozen. What do I do? spray ...
Question about Ryobi Garden
...trimmer for over 3 years, without an issue. However the blades have stopped moving but the engine runs fine. Is this easily resolved or has the motor seized. If the engine starts 'fine" then it has ...
...trimmer. My blades would not move. After tearing it apart, I found that there were some spacers under the 5 or 6 screws along the blades. These spacers are steel and designed so that you don't ...
Question about Oregon Scientific Garden
trimmer engine will not run at full speed engine runs at about half speed and hardly moves cutter blades - if I take drive shaft off it runs just fine - does this mean that is problem with centrifugal
...runs but blade doesn't move after hitting fence. Removed blade and it moves freely. Without direct exposure to this model, check the parts catalog, there is more than likely some type of ...
...Trimmer starts and runs but blades will notvmove There is a big steel cable/wire type thing e in side the tube of the machine connect motor too head and itz broken look at small engine shop ...
...or even WD 40. Might be something is rusted and won't let blades move. When you are done trimming reapply some oil to displace any water that comes out of whatever you are trimming. Good luck ...
...runs great, accelerator responds perfectly, but the blades stopped moving. Any ideas? Ensure blades are sharpened. If there are burs on blades they can seize. Blades should be lubricated with WD40 , ...
23 questions posted
Usually answered in minutes!
379 Questions
286 Questions
107 Questions