Sta Rite Ds3hf 1.50 Hp Self Priming Irrigation Pump "fill pump prime" Questions

...fill the pump going into the water until it is halfway full then kick the pump on and it should prime itself and leave a water valve open so it will not pump air. Also if it is a two pipe jet pump if ...

...pump, when I've filled the 1 inch pipe plug with water and it won't fill. have to fill the housing complete with fluid. make sure there is no more air in it. also make sure that is not poss. to **** ...

...in red under the STA-RITEremove the lid fill the pump up with about 3 gallons of water then replace the lid and start the pump. should start to flow in about 1 minute, if not repeat priming ...

...pump making a funny noise but not pumping. You have to prime the pump first. Turn off the pump, remove the priming cap, fill with water, close, then run it. Repeat as needed to get water

...pump you will just have to fill the pot with water. If not you will have to open a valve and force some water through the system to prime the pump. This being done, if you still have no water you may ...

...I prime the pump? If the pump is submersible it should be self priming. If it is external try filling the input and output pipes with a hosepipe and then switch on the pump. Regards ...

pump will not prime. Pump self primes after the housing is initially filled with water. Failure to do this will reslut in the unit not drawing up the water and could potentionaly damage the unit.

non continuous pumping The pump primes itself OK, fills the reservoir, then kind of burps, empties about half the water, then primes itself OK again. This repeats itself continually. But it never ...

...fill up the tank with water (about 3 gallons?)first this gives the pump suction it needs to start pumping IF YOU don't prime it it will burn up the shaft seal (in just a few minutes) and it will ...

...fill this with water and start the pump. if the pipework connected to the pump and the filter are empty you will usually have to repeat this process a few times, but once the pump is primed it should ...