rule 1800 pool cover pump trips breaker the pump was working fine now today it trips the breaker It sounds like the pump motor has shorted. Probably time to invest in another one.
...something wrong or if there is a problem with the pump. check that pool cover is not blocking filter intake.intake hose may need to be temporarily re-routed to a point below skimmer to drain
...pool cover pump will not run My Rule 1800 pool cover pump ran fine for a few months but will not run now. After you leave it unplugged for 10 minutes or so, it will run for about 2 seconds (in water) ...
...pool cover pump, which sits on a small tarp in the center of the cover ---- since our pool is surrounded by trees this makes it easier to get the leaves. In a wind storm the tarp blew loose and ...
Question about Rule Pool & Spa
I have an 1800 rule pool cover pump and it quit working, just quit contact rule they have a 3year warranty
...Pool Cover Pump Trips GFCI outlets. I have 2 pumps one works fine, The defective one obviously has a ground fault causing the GFCI outlet to trip. How to trouble shoot & repair? The motor on this ...
...that it's better than the Rule pool cover pump that keeps failing!) Here is the manual http://www.flotecwater.com/pdf/FP822%281-3-08%29.pdf domestic spa bath simer pump not working .any ...
pool cover pump quit working without warning. was not in deep water. pump is clean, no cracks or compromised wire. air vent hole not plugged. tried in a couple different outlets (power source) then ...
my swimming pool mega pump is humming when turned on and not pumping try when off to remove back cover on motor then try to turn motor shaft by hand then try to turn on might be rusted yes, thank post
106 questions posted
Usually answered in minutes!
55 Questions
47 Questions
21 Questions