Kenmore Elite Oasis 27052 Top Load Washer "remove wiring harness washer" Questions

...wiring connection or a broken wire harness could be causing this problem. You can remove the top panel of the washer by taking out the screws at the very back of the top panel. Pull the panel back ...

remove the panels and check the entire wiring harness layout in this unit. check the wires that run from the control board all the way to the electric motor and dispenser wires as well. check the door

wiring harness can also cause the error, but it is not as common a problem. Go onto kenmore.com and find your right washing machine and replace the part yourself. First try and take the wiring harness

...wiring harness can also cause the error, but it is not as common a problem. Whirlpool is the manufacturer of both model washers and recommends the following troubleshooting advice. Remove the top ...

...harness connection could be causing this problem is there is no water or suds in the tub. I recommend unplugging the washer and removing the top panel. Screws at the very back of the top panel secure ...

...Remove the three screws attaching the top panel to the rear of the washer then slide the panel rearward and lift it off the washer.Disconnect the User Interface ribbon connector from the left side of ...

...Remove the rotor (1-bolt), and the stator (4-bolts). When you pull the rotor off, check to make sure that the thin plastic beads that run between each magnet on the rotor is intact and in place. This ...

...wiring harness can also cause the error, but it is not as common a problem. Whirlpool is the manufacturer of both model washers and recommends the following troubleshooting advice. Remove the top ...

...harness connection problem, a failed user interface control board or a failed central control unit. I recommend calling a service technician to properly diagnose and repair this type of problem so ...

...wiring harness by removing the top panel of the washer. To remove the top panel just remove the three screws that hold the panel in place in the rear of the washer. With the screws removed, the panel ...