...pink and everytime i try and take a picture my screen goes black and shuts off without the camera piece going back in! I have almost the same problem except when I take a picture and go into the mode ...
...pink. Most likely youve damage the lcd screen either by dropping it even though you didnt, but that would be the only cause this problem, line on a lcd screen are usually cause by a broken power ...
pink and red on my screen. The pictures even come out the same way. I am afraid that heat might have caused damage to my lens? I left my izone 310 in my glove compartment during hot weather and now it
screen shows white and pink colour with horizontal lines. I turn off the camera and sometimes it can take pictures again. The camera was not dropped or anything else - water, sand etc... Actually it's
Question about Sanyo VPC Cameras
...pink on camera screen and when downloaded to computer-what would cause this? Perhaps you did select a SCN mode, with the main dial. Or chose a wrong white balance setting. Please switch the camera to ...
...screen is flickering. Took a photo and it is all pink. Battery is fully charged. Everything was fine last time I used it, a couple of days ago. Problem now solved. I switched the camera on and off a ...
...screen. The only time I have seen horizontal lines in the pictures, it was a prelude to the CCD sensor failing. Sounds like a CCD sensor problem.If the CCD sensor is causing the problem, it will get ...
Question about Sanyo VPC Cameras
...causes a pink section at bottom of screen when turning camera on? I turned on my camera today to take some pictures and there is about a 2 inch wide pink section at the very bottom of the screen. It ...
...screen turns pink in color and is unable to capture any images. The menus display properly as does images previously captured and stored to the internal memory. No memory card in camera when it ...
...screen like sort of purple-ish or pink-ish. If you know how to do a hard reset or if you know how to fix it, I would really appreciate it. Thanks in advanced. You can try to Recovery factory Settings ...
122 questions posted
Usually answered in minutes!
197 Questions
125 Questions
77 Questions
72 Questions
55 Questions