Question about Toyota Yaris
...a further by 90 degrees Head bolt torque must be done in 3 steps: 1st 22 ft lbs 2nd 43 ft lbs final 47 ft lbs use this sequence of tightening: 9 - 3 -1 -6 -8 7 - 5 - 2 -4 - 10 Flywheel spec: 65 ft ...
Question about Toyota Yaris
torque setting for main bearing and big end bearing of a Toyota Yaris 1.0 1kr 3 cylinder? Toyota Yaris Main and Big end Torques: Tighten the main and big end bolts in sequential order and in steps two
...quality torque wrench and torque angle gauge to ensure that the bolts are tightened to the correct specifications. Over-tightening or under-tightening the bolts can lead to engine damage or
Question about Vauxhall Cars & Trucks
torque setting and sequence Cylinder head Renew bolts: Yes Tighten: 25 Nm Tighten: 90° Tighten: 90° Tighten: 90° Other engine tightening torques Main bearings Renew bolts/nuts: Yes Main bearings Stage
Question about Toyota Yaris
torque settings. Here are some additional tips for tightening the big ends and cylinder head: Make sure that all of the bolts are evenly tightened. Do not overtighten the bolts, as this can damage the
Question about Toyota Yaris
...tightening the torque settings: Use a torque wrench to ensure that the bolts are tightened to the correct torque. Tighten the bolts in a star pattern, working your way from the center out. Do not ...
Question about Toyota Yaris
torque settings for the Opel corsa1.4i crank mains and big ends Please note: You must use new bolts as these are torque to yield bolts, in other words they are a type of linear spring. Connecting rods
Question about Toyota Yaris
...Torque the bolts up to 17 Nm. Stage 2. 34 Nm. Stage 3. Rotate all the bolts 90 degrees. Stage 4. Finally rotate all the bolts further 90 degrees. Main Bearings: Tighten the main bearing bolts in two ...
Question about Opel Cars & Trucks
...stage 1 tighten 50nm stage2 tighten 45degrees stge3 tighten a further 15degrees. big ends renew bolts stage 1 tighten25nm stage2 tighten a further 30degrees use a torque wrench and then a angle ...
Question about Hyundai Cars & Trucks
TIGHTENING TORQUE [1] : 1st sequence: 40 Nm (30 ft lb) 2nd sequence: 60 Nm (43 ft lb) Final sequence: plus 1/2 turn (180°) Here are some additional specifications, thanks ntake Manifold Mounting Bolts
195 questions posted
Usually answered in minutes!
615 Questions
92 Questions
49 Questions
45 Questions
20 Questions