2008 Jeep Grand Cherokee "1996 auto shut" Questions

...1996 is about the year that OBD II, came about. Not sure witch one you have. OBD I, cars could clear codes by removing negative battery post. Problem doesn't always leave. I'd take it to an Auto Zone ...

Auto shut off fuse keeps blowing,why? The short answer is you have something pulling too much current in the circuit. The long answer is that circuit powers several other relays, so you may need a ...

96 jeep 4.0L 2wd 6 cyl. shuts off when it heats up. i drive 15 min or so and always shuts off. my transmission is going out. my ignition went out too. could that cause the issue at hand? have tries ...

and down some in neutral, If that doesn't help you will need to check the starter wires with a test light to see if power is getting to starter,it could be a starter,starter relay,Auto shut down relay

When I turn ignition,.vehicle starts, but immediately cuts out and engine shuts down when I take my foot off the gas. Could it be a loose throttle cable affecting my idle? It could be related to ...

...1996 Jeep Grand Cherokee 6 cyl. Mine was the Camshaft Position Sensor. Only available at the dealership and cost $85.00 at the parts counter. Easy to install - remove the distributor cap and rotor. ...

...shut off wiat another two to five minutes it will start back up,whats the problem you need to check this when it does not start fuel pressure at the fuel rail , spark at the plugs, power at the fuel ...

...auto shut down relay). They are not expensive, and I would replace it and see if this is the issue. It seems you have covered everything else as far as part replacement, at this point, the ASD relay ...

...auto shut down fuse started blowing as soon as i try to start it Check for a damaged inertia switch in trunk area what fuse number located where? photos work here,! with that , we can tell all ...

...from because it happins so fast, the jeep starts and I go. check the auto shut down relay and wiring. Try getting it plugged into a code reader, that should identify a low or high voltage ...