heat pump, all you need to do is pull stat wire from the indoor unit control board to control the condenser with 5 conductors, but you will only use 2 wires for the control of the condenser. Normally,
...wire up. Many thanks. Is the unit an AC only or a heat pump? Wiring to the units should in the manual or online. Both units proper house voltage to inside unit and outside unit.There will also be a ...
...wire should be going to Y2 on the air handler and probably does not continue out to the condenser. The Y2 should be going to the contacor that brings on your backup heat. It seems like Y1 and Y2 are ...
...heat pump condenser? look on the indoor unit and see what they do you hav common from trans former yellow for compressor white for elect heat then reversing valve usually orange green for fan on the ...
Question about American Standard Heating & Cooling
...heat pump compressor and condenser fan run when I have the thermostat set to emergency heat? The condenser unit is 4A6B4042E1000AB it is a R-410A system. The air handler is a 4TEE3F65B1000A It's ...
...heat pump does not turn off Condenser fan runs all the time even when off at thermastat If it is just the condenser fan that means you have a fan relay that has welded shut. Turn power off to your ...
...heat pump that works fine in ac mode but does not heat only have heat in emergency .condenser fan does come on when heat is selected the heat pump is either wired wrong on the low voltage side or the ...
...instead of replacing a heat pump and need the new wiring diagram Same as heat pump with the exception you will only be using two thermostat wires. C & Y. They will power the contactor
...wire, W1 and W2 is the heat strips in the furnace tan and black wires. These are standard color code but remember electricity does not know colors and an installer may have used different colors. If ...
217 questions posted
Usually answered in minutes!
1,056 Questions
416 Questions
147 Questions
138 Questions
100 Questions