Same as the pickup chassis it's based on. On the frame under the driver's door. But be careful!!! Ford used some strange filter connections over the years. MAKE SURE you know which one you have before trying to get the filter off. If you destroy the clip/line on some of them it cannot be fixed. You would have to replace the whole line. $$$$$$
SOURCE: location of the crank positioning sensor on a Ford
The CPS is located in the engine block right next to the A/C compressor. You'll have to unbolt the compressor to have room to remove the CPS. Don't remove the A/C lines, just unbolt the compressor so that you can move it out of the way. There is one bolt holding the sensor in place and you can just pull it out after you remove that bolt.
SOURCE: where is the fuel filter located for a 1997 Ford
should be on the frame, like, under where the driver sits.
SOURCE: can't find fuel filter on 2004 ford e350 van
the fliter is rite before the rear driver wheel. u will need a disconnecting tool to remove the line from the filter. ten min job the most. make sure to have a old rag to catch the run away fuel or just remove the fuel pump relay, crank the van and let it run until it dies then removr the lines.make sure to put the new filter on the rite way
in the motor compartment fuse distrubution box under hood
Testimonial: "It would be helpful to know in relation to the radiator where the fuse distribution box is located. I have one fuse block under the dash near the steering wheel and 6 fuses in the right wheel well. There are 2 relays under the hood on the right side of the center of the hood, but the numbers don't match the part number on the relay available at Autozone. Thanks for your reply."
807 views
Usually answered in minutes!
×