After having a ball joint replaced, truck started cutting out at highway speed. It will catch itself and keep going. Usually after hitting a good bump. Also cuts out completely at low speed usually when making a turn. It can be restarted without problem when it dies. Dealer found map sensor code and replaced map sensor but didn't solve problem. truck has 95 k miles.
Sounds like balljoint not installed correctly
SOURCE: diesel. starts cuts out intermittently
have u checked there is nothing blocking the pipes in the tank, i had this problem someone had put paper in as tempory filler cap
SOURCE: my car cuts off at low speed, usually when
The EGR valve may be sticking open.... most likely ...
Possibly clogged fuel injectors... (not as likely). Use a brand name fuel injector cleaner ($6 AutoZone) or "complete fuel system cleaner ($8 AutoZone). No store brand stuuf, just name brand.
SOURCE: Does a faulty crank sensor set a code on a 2001Silverado
It should set a diagnostic fault code, but if it does not then take out the sensor and inspect for a crack in it or motor oil in the electrical plug connector which indicates a faulty sensor.
SOURCE: I have a 1990 chevy truck, it Idols high - low in town
You may have an Air Idle Solenoid and or Idle Speed Motor. Not familiar with you vehicle. Check that out.
SOURCE: Engine dying while running full speed and
This is an electrical problem, I had this last winter where the car was restarting or the starter was not disengaging. The problem was with the starter. the contacts that meet the plunger in the starter were grooved severely and binded with the contacts.
I had to replace the contacts inside the starter.
195 views
Usually answered in minutes!
×