It Idles fine when I adjust it but when I start it up with the choke and let it sit till it sounds like its ready to ride. I put the chock inn and the bike starts to ride horrible. I cant get the bike to shift into a different gear without it sounding like its going to blow up. I have been using the little screw to take the idle down but hasn't worked.
TRANS HAS A WORN GEAR THAT IS WEARING UPON 2ND SHIFT
SOURCE: my 2003 yamaha banshee will shift threw all gears
Check the gears mabey they are skipping when the bike goes to fast. like at 3/4 throttle theres to much torque an it just wont catch.
SOURCE: idles revs by itself
You have an air leak in the intake system. The fuel mix is getting lean from excess air mixing with the gas. New gaskets and seals between carb and head will usually take care of the problem. Any oil stains around the base of the cylinder head? Head gasket going bad.if there is. The gasket could be the leak. Time for a valve job? Air getting sucked in past an exhaust valve or two? Have the compression checked. Find the leak(s) and you find the fix.
Please rate this solution. Thanks!
SOURCE: I have a 1997 tw200. It runs and idles fine, but
Sound like it could be a problem with the side-stand cut-off switch. (It is to prevent you riding away with the side-stand down.) They are notorious for getting crud in them and sticking.
Hope this helps!
SOURCE: yamaha tw200 2003 dies giving gas. idles fine. wtf!
You are getting enough fuel. ck for trash in your carbs
SOURCE: 2007 yamaha ttr 125 wont go into gear. starts
gear selector may be jammed inside the casing or broken
check that the shifter is tight on the shaft!
check clutch adjustment
try rocking bike back n forth without using clutch while you try ******* the gear lever it may come unstuck
but get it looked at if it frees up!
This is the transmission and clutch. The ENTIRE engine tears down, top end, clutch, shifter, kick starter, flywheel and electrics, forks and drum, crankshaft etc. Needed tools are a flywheel puller, case splitter, torque wrench, impact driver and circlip pliers. This is not a beginners project. You can get a factory service manual and give it a try but I don't recommend it. The service manual may or may not have a power transmission diagram. I don't have a diagram for this engine.
240 views
Usually answered in minutes!
I'm now noticing a leak of oil under the bike
×