Wont rev kia carens 2.0 ltr diesel 2006 starts and ticks over but wont rev up and smokes

SOURCE: dashboard emission warning has come on but my kia carens is running fine ?

Have the sedona scanned at an AutoZone or similar place and ask for code. they will not tell you whats wrong with it but they will give you a code. You can go from there. You can come back and tell us what the code is .

SOURCE: Diesel smoking and lack of power

on my sorento same problem and its solved vacuum pump on turbo, now ok, sorry for bad english, vacuum membrane is broken

SOURCE: kia rio 1500 diesel 2006

This would appear to be the start of GLOW PLUG failure. Raise the hood and Swich On the Ignition.
With a volt meter,... test the supply voltage on the Glow Plug supply terminal connection. If this is GOOD, Switch Off the ignition and remove the Key.
Remove the Glow Plugs with a Long shank socket.
Make up a length of 14/16 gauge wire, stripped about 1 inch from each end. Attach 1 end to the Battery Pos.+ Terminal,and holding the other end, take each Glow Plug in turn,and hold the PLUG BODY onto the Neg.- Terminal, and TOUCH and HOLD the wire to the Plug TERMINAL CONTACT. If the Plug is GOOD it will SMOKE and GET HOT. If more than 2 Plugs do not react then JUNK them ALL, and replace them. If only 1, then just replace it solely. Make sure on re-installation, that the PLUG, is FIRM and SNUG in the receiver. Disconnect your Supply from the Battery, and attempt Start Up procedure.
Let me know how you get along.
Regards.DT

Auto Repair Help

• 1420 Answers
• Posted on Feb 14, 2010

SOURCE: 2006 Kia Sorento 4X4, Diesel. Starts right up

i would check all the basics like spark plugs and check for vacuum leaks around the intake manifold.With a can of 2+2 carb cleaner while engine is running --if idle goes up or down that is were your leak is--
check egr too, Lee

SOURCE: KIA CARENS Drivers door wont open

FIRST: If it is under warranty, take it to the dealer!
If not, from your rather limited description it sounds as though the attachment rod that operates the latch mechanism is either so loose or disengaged that it will not rotate the security latch to "unlock" your door. Open up the attachment point and the panel to determine what exactly has loosened or failed and replace the hardware and then properly secure eveything.

Testimonial: "thanku"