Timing marks for a 2004 ford focus 2.0dohc - 2000 Ford Focus

depending on trans and engine mount type the mark my be on flywheel but generally most cars it is located on the belt pulley attached to crank rod, center bottom one on engine block. the timeing mark should be visable from top looking down. if you use a big ratchet to turn over the engine by hand and go slowly, you should see thhe marks pass as you do so.

Are you needing the twin independent variable cam timing info or is this a cam replacement initial cam timing setting? the variable valve timing itself is dependent upon the part design, and is usually controlled by oil flow (causing the timing to change hydraulically and seems transparent to the driver). However, when replacing the cam, the timing is more of a position issue using the marks on the engine and camshafts to make sure the shafts are in the proper position.
If this is for a replacement, use the marks on the block ensuring the current valve position is the proper in relation to piston position (otherwise your pistons will punch the valves and blow the head)

http://www.automecanico.com/auto2002/avanzada.html

go and translate to english and see your model and execute.

God bless you

Both engines, 2.0 and 2.3 have timing belts.

the cams have slots on teh back of the cams with rocker cover removed and the crank mark is through a little hole slot on the bellhousing

Ford Focus 2000-2005 2.0L

2.0L (VIN P) Engines

Fig. Align the timing marks before removing or installing the timing belt-2.0L (VIN P) engine



Fig. Crankshaft alignment position-Ford 2.0L (VIN 3) engines



Good luck (rated this help).

Your adjustment screws should be white nuts (adjustable with an allen wrench, or a socket, or a pair of pliers) located behind the headlamp assembly right up against the fender

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall. You only need to do this and the aiming for your low beams as your high beams are on the same bulb

Your headlights should also say VOR. When you turn on your headlights, aim them right at the mark that you put on the wall, with the brightest cutoff directly under the mark

In the Timing Belt and Serpentine Belt calagogue dont have 1.6L, only for 2.0L and 2.4L; maybe this can help you.


2004 Ford Focus 4-Cyl. 2.0 L

Timing Component Kit; W/DOHC Eng.; W/1-Idler Pulley




Timing Component Kit; W/DOHC Eng.; W/2-Idler Pulleys




Timing Component Kit; W/SOHC Eng.





I hope help you with this. Good luck.

Double check the timing marks on the crankshaft and cam pullies. I bet your off by a tooth after replacing the timing belt.

Transmission warning light :)