SOURCE: I need timing specs for 3.5 2002 Isuzu Axiom
I have found that one can mark (Paint pen) the gears and teeth (One tooth and one corresponding belt rib) on each gear prior to removing the belt. You can then overlay the old belt on a new belt and mark the same spots on the new belt and then install the belt so your marks on the gears and belt line up as they did before you removed the old belt. Given that your timing was right to start with....if done correctly, this will work.
SOURCE: Just need to know about timing marks, please
when you pop the hood look around you should see a sticker that will tell you
SOURCE: Isuzu bighorn diesel 4jg2 engine timing diagram
http://www.jeepolog.com/UserFiles/downloads/trooper_manual.pdf
This site has it .
SOURCE: isuzu trooper 2002 RLV engine. camshaft timing
Sorry for the severe delay.
I am personally going back to answer your unanswered question.
I do not know if you still need the answer, but I am going to answer it in case you still do.
Click on the following direct Link. It has the Timing Belt Diagrams and Photos with Marks for the Camshaft and Crankshaft that you will need. It also has numerous other helpful diagrams, instructions and photo's for use.
Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/2002/make/isuzu/model/trooper/2002_isuzu_trooper_timing_belt_diagram_marks.htm
SOURCE: Specification of 4JG2 Engine-Isuzu
Four cylinder inline, water cooled, overhead valve diesel engine with dry liners available in Turbo(T) or normally aspirated(NA).
Bore 95.4mm
Stroke 107
Displacement 3.059 litre
Compression ratio 20:1
Idling speed NA 750, T 720 rpm
Firing order 1-3-4-2
Injection timing NA: 1 deg after top dead centre(ATDC), at top dead centre(TDC) for turbo
Valve clearance (cold): 0.4mm for intake and exhaust.
79 views
Usually answered in minutes!
×