At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Trans could be stuck in limp in mood, may just need to replace the speed sensor, or diagnose the no speedo problem.. Trans relies on speed sensor info to shift
Put the control (on the driver door for your side view mirrors) onto the passenger mirror position put the car in reverse, mirror tilts down and shows you the curb! (this only works on some models like the 3.0 not sure of what year of 1.8t)
U will have 2 isolate all the wires so they cant touch each other & the body work -steel - just use some electrical tape 2 prevent wires touching!!!!! Or open the door & look 4 the plug C if U can pull on the plug 2 disconnect it!!!! Good luck!!!!
Mirror, Power — Outside Rear View
NOTE: This procedure applies to both RH and LH power outside rear view mirrors.
Removal
Remove the front door trim panel (23942). Refer to Section 01-05 for the removal procedure.
Remove the two outside rear view mirror inside mounting hole cover screws and the outside rear view mirror mounting hole cover (17K709) from the front door (20124).
Remove the wire clip.
Disconnect the power outside rear view mirror electrical connector.
Remove the three power outside rear view mirror bolts and the power outside rear view mirror.
Installation
To install, reverse the removal procedure.
Tighten the three power outside rear view mirror bolts to 3-4 Nm (27-35 lb-in).
Glass, Outside Mirror Removal and Installation
Refer to the glass replacement procedures in Manual Mirror for power outside rear view mirror glass (17K707)
Trim Cover Removal
Remove the front door trim panel. Refer to Section 01-05 for the removal procedure.
Remove the two outside rear view mirror inside mounting hole cover screws.
Remove the outside rear view mirror mounting hole cover.
Installation
To install, reverse the removal procedure.
Mirror Control Removal
Use a small flat-blade screwdriver to pry the power outside rear view mirror control switch from the instrument panel (04320).
Shift to reverse, adjust the mirror for normal, and save that to memory for that operator. This is presuming that you have not found a setting to turn off reverse mirror settings.....
make your self a jumper set of wires to test with. Find out what makes what move on the old unit,write down the color wire,then apply power and ground to the new unit onw wire at a time.Mark down the color and what function it did.after testing both units then match your research and put the wires together.I wished I were there.Good Luck!
×