Question about 1992 Mercury Sable

2 Answers

Where is the oil pressure sensor on a 1992 mercury sable

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I know where it is , i had to do some open heart surgery on my car but i found the little thing ,,,,, it is under your power steering pump . take off the belt ,remove your alternator and the tension wheel below it and look through the hole and you can see the oil pressure sensor ... what a stupid place to put it

Posted on Nov 06, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 659 Answers

Front of engine right by the oil filter

Posted on Jul 15, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2005 Mercury Sable, it shows the oil is full on the dipstick but the low oil pressure light has come on twice, what could it be?

Low oil pressure has little to do with oil level. The best is to take it to a service agent to have the oil pressure checked. It is very possible that you have a faulty pressure switch, and just changing the switch will solve the problem, but if you have an oil pump problem, causing low pressure, you have a major problem. Have it checked.

Mar 13, 2015 | 2005 Mercury Sable

1 Answer

What would cause oil to be in the radiator in a 1992 mercury sable

What colour oil is it, if it's white or red then it sounds like the tranny oil is leaking, but only if it is a automatic, if a manual then it has migration of oil into a water jacket and will need to be fixed, by replacing the head gasket

Sep 15, 2014 | 1992 Mercury Sable

1 Answer

How do I take out the air bag and replace it with another one for my 1992 mercury sable?

You don't. .take it to a reputable garage and let them repair it.if you just install a new air bag without replacing crash sensors, clockspring, air bag module and safing sensor, you may deploy the new air bag,possiably causing major bodily harm. ..stay away from it!!! A static shock from you connecting it could set of air bag..

Mar 04, 2014 | 1992 Mercury Sable

1 Answer

2001 Mercury Sable: code for System Lean to Bank 2= Car Idles too high. Possible causes?

sounds like a air leak ,, bank 2 sensor 2 ?? refers to after the catalytic converter ... could be a faulty sensor but more likely an air leak .... even a faulty fuel tank cap seal is enough to cause problems on these systems

Nov 06, 2013 | 2001 Mercury Sable

1 Answer

1992 mercury sable will turn over but wont start

Make sure battery has a full charge. If it cranks good but won't start, check the basics. Have a helper crank it while you visually check for spark at the spark plugs, if spark everywhere, use a gage and check proper fuel pressure. I looked at info for the 3.8L engine, 35--40 psi. Also, after you build fuel pressure, turn off the key, see if fuel pressure holds for a bit? If the pressure drops like a rock, check for fuel pressure leak. Check the vac line for fuel pressure regulator, if it has gas in it, the regulator is faulty, or a leaking fuel injector. The pressure could also drain back through fuel pump.
Also, check fuel injector pulse, engine cranking. Any applicable trouble codes?
Smell of the crankcase oil dipstick, if it smells like gas, either you don't change oil and filter very often or the engine is running very rich for some reason.

Jun 24, 2017 | 1992 Mercury Sable

2 Answers

I have a 1992 Mercury Sable that I bought less than a month ago and it's low on oil...I was wondering exactly what type I should put in?

Any good API (American Petroleum Institute) approved oil will be fine (stamped on bottle) 10w-30 or 10w-40 will work,

Feb 27, 2011 | 1992 Mercury Sable

1 Answer

Transmission shift soleniod

inside the transmission oil pan

Feb 26, 2010 | 1992 Mercury Sable

1 Answer

No oil pressure, camshaft position sensor error,

Yes, the sensor is in small housing the goes in the hole where the distributor used to go. That also drives the oil pump so don't drive it you'll ruin the engine. It's located down under the throttle body, near transmission end of the engine.

Jan 04, 2010 | 1997 Mercury Sable

1 Answer

1992 3.0L Mercury Sable cylinder numbers and firing order

For the 1992 Mercury Sable 3.0L V6:

Firing Order:



Let me know if this helped, or if you have additiional information or questions. Feel Free to contact me at!

Nov 17, 2009 | 1992 Mercury Sable

1 Answer

How many 02 sensors are there on a 1992 mercury sable? I know one is by the catalytic converter, if there is another one where would it be?

IF there is another (and I am pretty sure there is) it should be on the exaust manifold..

Please dont forgt to rate well ;o)

Aug 13, 2009 | 1992 Mercury Sable

Not finding what you are looking for?
1992 Mercury Sable Logo

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

76649 Answers


Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides