Question about 1998 Saturn SL
If the temperture is below 30 deg. it could be you have water in the fuel lines and freezes and stops the fuel from getting to the engine. use gas line anti freeze.
Posted on Apr 28, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
are you sure you got the wires back on tight? Also it sounds like the bendex is not kicking out like it is supose to.....Did you change the starter cylenoied?
even some new starters are bad, it doesent happen much but it does happen. You might even take the starter back out and run Jumper cables to the starter. See if the bendex will kick out and stay out untial you diconect the starter......Sorry for your run of bad luck and I hope this is of some help.
Posted on Jun 21, 2011
if it does not crank then you might need a starter, if it does crank the you have to check to see if you have fuel pressure
Posted on Jul 01, 2011
Check the dash once you turn the key to the run position the passlock runs a security check using a set resistance value through the chip in the key. If the security light begins to flash the reading it received was incorrect or it didn't get a reading at all. You can try reseting the value it is looking for by turning the key to start then releasing it. After 10 minutes turn it off then cycle it start again leaving it in on for 10 minutes then back to off then one more time. After the third cycle has completed for a total of 30 minutes. You should be able to turn the key on and start the vehicle. If the light continues to flash their is a problem with the chip in the key or the connections within the ignition its self. Both are common but a Pass Lock Relearn as described above will usually adapt to the poor connection values. Hope this helps.
Posted on Sep 09, 2011
Tips for a great answer:
Jul 09, 2013 | Cars & Trucks
on Jun 16, 2011 | Lincoln Continental Cars & Trucks
Aug 08, 2012 | 1991 Ford Explorer
Apr 08, 2012 | 2005 Ford Falcon 4.0
Jan 18, 2012 | 2007 Chrysler 300 AWD Sedan
Aug 28, 2011 | 2001 Volvo S60
Jul 23, 2011 | 1999 Buick LeSabre
Jun 04, 2011 | 2006 Dodge Durango
Jan 25, 2009 | 2003 Chevrolet Blazer
81 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: