Re my 2002 ford explorer sport trac. First thing in the morning or after its been sitting awhile when put in reverse the engine surges. It jerks until it is put in drive. I tried engine cleaner once with little success at resolution. I have also tried gassing it repeatedly with no slow down in surges.
Make sure air duct from filter to throttle body is not torn allowing unmetered air into system causing bad idle .
Spark plugs
SOURCE: on my ford explorer truck when i stop it acts like it wants to go forward
must connect scan tool to read fault codes...sorry
SOURCE: surging while driving
DO NOT waste your money on tranny solutions!!! I have a 1998 Ford Windstar. About 2 years ago I started noticing a strange almost shaking, jerking serge type of activity when I would get into the "mid-range" (30-50) on the speedometer. I took it to a very trusted mechanic. After about $2000 and several different "tranny solutions", I thought the problem was fixed until about two week later when it suddenly jerked and sputtered AGAIN!! Don't waste your money on tranny issues. (by the way.. my van has also recently had a new tranny put into it and it STILL HAPPENS)
SOURCE: Windows will not operate on my 2003 Ford Explorer Sport Trac
window relay module probably went bad. theres a window relay under the dash you have power . try getting a wiring diagram mabey at an auto parts store or the library. so you can trace the problem down . short of taking the doors apart and checking the motors that drive the windows . Old fix with the old school cars bang on the doors from the inside with fist . it sometimes works the connections on the old school cars . Its stupid but it worked to get the window up .
SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
SOURCE: 01 ford explorer sport trac rear timing chain diagram
They will not loan you the tools.....how else will they continue to rip off the average garage junkie and make lots of money?
371 views
Usually answered in minutes!
×