1998 cavailer 2.2 wont run it h as fire, crank

No power to fuse block? This may be the problem. Check all your maxi fuses in the power distribution block. I think all the maxi fuses are hot at all times-check if they are getting power, and fuses are good.

Also in the power distribution center is fuse F15- a 30amp fuse for fuel pump relay, and fuse F6- a 15amp fuse, also for the fuel pump wiring. Check that both are good, and have power-F15 is hot at all times. F6 is hot in run or start.
This is the 4.0L inline 6, right? That is the engine diagram I have. The coil signal is from the ECU. Does the check engine light come on with key on, so you know the ECU is powered?

Did you get the oem parts from the dealership? If you got cheap ones at the auto parts store that is the problem. Now you have to buy them again.

Check your Cam,MAP,MAF sensors.

check the car computer or control box.sammyc47.

Can you here the fuel pump running?no, check fuse,and pump relay. Check pump fuel pressure,at the fuel injector rail,or throttle body. Check for voltage at the top wiring on the fuel nozzel.While cranking look for pulsating voltage.None, test computer,scan system. let me know the outcome.

It is on the front of the motor just under the rear part of the waterpump in the timing cover. But I doubt it is the problem. Sounds more like a bad crank sensor. Which is located behind the crank pulley.

have you tried resetting computer, hot wire off battery for5 mins or so

crank sensor

Sounds like the control module.

crank sensor or cam sensor