How do i replace a new foglight? what do i take off?

You are aware the headlights must be on low beam before the fog lights will come on?

you can get help from the service and repair manual this will guide you step by step with diagram to solve your problem to get the manual go to the given link http://toolsnyou.com/

I found the easiest way to change the fog light bulb is to take bumper off, takes 5 mins, 5/6 screws/clips across the top were the bonnet meets the bumper and a few clips on wheel arches then pull off and 2 spot lights very easy to Accra.

The headlamp knob doubles as the foglight switch. You just push it in. Its the middle knob in this picture if it posts right. Hope this helps.

Remove the entire foglight assembly check for a loose wire inside the assembly. I had the same problem on mine but it only affected one of the foglights. Also check with a test light at the connector where it connects into the foglight assembly. Also make sure foglight bulbs are properlly tighted.

Log on to www.autozone.com. You sign up for a free online account and add your vehicles to your virtual garage. When you add a car, they give you access to free manuals online that have diagrams and how-to information, among which are electrical system schematics and diagrams.

i hope this helps you a little,
matt

get replacement lamp assemb. dissconnect plug from lamp remove attach hardware and reninstall new lamp royedwardtat

Bought a new switch.

if you wired them into the factory harness, then you will have to add a factory switch. however you can wire an aftermarket switch directly to the foglights, bypassing any factory harness