2001 olds aurora, 3.5 ...0442 diag code..where is evap filter and lines located

Reset Engine Check Light CodeS?? You need a scan tool or buy a FIXD Module.

How can you reset a computer for a 2001 olds aurora? ' The ...

oldsmobileforums.com > ... > Oldsmobile Aurora

Jan. 14, 2009 - Go to your local auto parts store and have them do a free code test to see the problem.They can clear all the codes and if it returns then replace ... I need the passcode too reset my stock stereo in my 2001 olds ...
Oct. 17, 2010
Blinking Engine light on a 2001 Olds Aurora 4.0? ' The ...
Feb. 16, 2009
More results from oldsmobileforums.com

Reset the Check Engine Light? ' Aurora Club of North America ...

aurorah.proboards.com > thread > reset-check-engine-li...

Oct. 26, 2008 · 10 posts · ‎7 authors
I am getting an Evaporative CEK code, and want to try replacing a few ... 6-1532 of the 2001 shop manual. ... 2001 Oldsmobile Aurora 3.5L ... How to unlock your Theftlock radio ' Aurora Club of ...
28 posts
Sep. 26, 2005
Theft System Fault? ' Aurora Club of North America ...
30 posts
Oct. 19, 2011
DIC: "Check Gas Cap" message ' Aurora Club of North ...
22 posts
May 18, 2008
Flashing check engine light ' Aurora Club of North ...
28 posts
Jul. 7, 2008
More results from aurorah.proboards.com

check and replace if needed,spark plugs,air filter,make sure brakes are not dragging,hook up a system analyzer check the codes

The Oldsmobile Aurora was a mid-size luxury sports sedan made by the Oldsmobile division of General Motors and launched in 1995. No numbers available on how many were built in 2001. --------------------------------------------------------------
actia multi-diag

sir .
go to that link refer it very useful information
you will have it all
http://www.aa1car.com/library/evap_system.htm
happy to help you inform mr if need more help or clarification after reading

Should be under the middle of the car towards the drivers side. Follow the fuel lines from front to back and it should be near the EVAP canister.

replace the Crank Shaft Position Sensor.

front of the fuel tank a few feet away.. just follow the fuel lines to it. it has snap in clips going into the filter ends

No there is not suppose to be a spring under your oil filter, so i don't know what your looking at. Please get back to me, like to know what you have???

This is the evap purge control circuit....proper diag requires alot of componet testing and equipment.... you might try replacing the evap control valve ( usually on the firewall area), and hope it was it...or get it properly diag at your dealer/shop..no simple answer/fix.......GL

there has to be some type of sensor around where the cap goes on that is either dirty or faulty.