Where do i locate the crank sensor on a 92 buick century? i changer the harmonic balancer and now the car wont start any diagrams or pics would be great!

harmonic balancers don't cause ck engine lghts , but crank position sensors that are mounted right next to them sure do

Crank Position Sensor ? (located behind the harmonic balancer)

very common problem the crank sensor located by the harmonic balancer.sometimes you can take long screw driver and tap on it may change it, also mass air flow meter located in air box area, check vacuum leaks. good luck ,mike

it is located behind the harmonic balancer. you will need a harmonic balancer puller

Behind the large pulley at the lower part of your motor. You have to remove the belt and then loosen the large bolt that holds it in place. Use a pulley puller to remove the harmonic balancer. With that off, loosen the screw that holds the bracket to the mount. Position the new bracket on the mount and tighten. Be sure that the gaps in the new sensor are postioned correctly. Replace balancer and belt and you should be good to go.

Crank sensor is located behind the harmonic balancer on right side of car, Jack up right side and stabelize, Remove right wheel for better access

Should be located behind the harmonic balancer on the bottom of the motor. You'll need a balancer puller to remove it.

yes besides causing a vibration while driving and possible throwing belts the balancer out of balance can cause problems with the lower end crankshaft such as seal leaks ,bearings and if breaks off or apart can cause damage to engine and body

you will need sockets,the crank bolt i belive is 22mm and you might need in impact wrench to remove bolt. the crank sensor is 1/2 in or 13mm, that a rachet is good.and to remove balancer sometimes youll need a puller. hope this helps.

Hello, the crank position sensor or (CPS) censor is located directly behind the harmonic balancer (or fly wheel at the very bottom). The sensor is located on the right side of the harmonic balancer when facing the front of the motor. You must remove the harmonic balancer to replace the sensor. You must also re-align the sensor with 30 thousands of an inch tolorence, or your car may idle rough or may not start. I own a 1990 Buick Century and just replaced my CPS sensor last month. There is a trick I learned to reinstalling the new sensor. Let me know if you need that information.