I really don't know the answer to your question but you can turn it on and test all fuses to find which is blown. Or, what I did was to place the '2006 dodge grand caravan fuse diagram' in your search box and press the search and look down the list to find which is yours. That's how I got the full diagram for my '99 ranger just to find which fuse powered the speakers so I could put a switch on it. It always drained the battery and this switch on that fuse worked. No more battery drain.
Testimonial: "My problem is not the location! It shows on the lid of the fuse compartment! My problem is that there is no contact pins in the holes where you put the fuse!"
SOURCE: 2006 Dodge Grand Caravan - EGR code
I replaced the EGR Valve ($80 after tax), problem solved, vanruns great now. Now my problem is that I can't get the light to turn off.
SOURCE: Dodge 2005 Grand Caravan water Pump replacement
JUST COMPLETED THIS JOB TODAY. MAKE SURE THE ENGINE HAS COOLED DOWN . IT TOOK APPROX 2 1/2 HRS. DISCONNECT THE NEGATIVE POST ON THE BATTERY. JACK UP PASSENGER SIDE FRONT AND SUPPORT ON JACK STANDS. REMOVE PASS. FROUNT TIRE. DRAIN RADIATOR INTO CONTAINER FOR PROPER DISPOSAL OR REUSE. USING FLOOR JACK PROVIDE SLIGHT TENSION ON OIL PAN WITH A SHORT 2 X 4 WOOD PIECE TO PROTECT OIL PAN. LOOSEN 3 ENGINE MOUNT BOLTS ON PASS. SIDE OF ENGINE COMPARTMENT. ALLOW APPROX 1" BETWEEN SHOULDER OF BOLTS AND MOUNT. LOWER ENGINE UNTILL BOLTS ARE SET ONTO MOUNT. REMOVE ENGINE SPLASH SHIELD INSIDE WHEEL WELL OF REMOVED TIRE. LOCATE WATER PUMP AND LOOSEN 3 PULLEY MOUNTING BOLTS (THIS IS WHILE BELT IS ON PULLEY) REMOVE SURPENTINE BELT AND CONTINUE TO FULLY REMOVE THE PUMP PULLEY. IT WONT COME OUT AS THE PUMP & PULLEY HAVE TO COME OUT TOGEATHER. REMOVE 5 WATER PUMP BOLTS AND CAREFULLY WORK WATER PUMP OUT BETWEEN THE ENGINE AND VEHICLE FRAME. CLEAN ALL MATING/GASKET SURFACES AND BOLTS. USING A SMALL AMOUNT OF TACKY SEALENT TO INSURE THE NEW WATER PUMP SEAL STAYS IN PLACE, THE INSTALL IS PRITTY MUCH THE REVERSAL OF REMOVAL.
GOOD LUCK, REMEMBER TO TIGHTEN ALL BOLTS TO MFR SPECS AND BLEED THE AIR OUT OF THE COOLANT AS REQUIRED.
SOURCE: how to install egr valve on 2006 dodge grand
You cannot clean them purchase a new one and pull the old one out of the valve cover, and disconnect the hose that runs to it. install the hose on to the new egr with a new worm clamp and push the other end into the valve cover. should take about 10 minutes.
SOURCE: NEEED FUSE FUSE BOX LAYOUT FOR 2003 DODGE GRAND CARAVAN
You can get free owners manuals online at:
http://www.edmunds.com/ownership/howto/articles/120189/article.html
or just type "owners manuals" in your search.
Here is a post I found that worked for my 2005 caravan.
For a
2001 Dodge Caravan: The owner's manual is vague, only stating that all
fuses are under the hood in the fuse box, no diagrams. Once you have
removed the fusebox cover, the diagrams for what each fuse does is
provided under the lid. UNCLEARLY marked is the radio fuse, a 20amp
fuse located 2nd row from top to the right of the accessory relay. It
is marked: RDO/IP IGN.
Jake
SOURCE: 2002 dodge grand caravan fuse box
The fuse box is located under the hood. There is component map printed on the inside of the cover. This tells you on your model where the fuse or relay is located
169 views
Usually answered in minutes!
×