When can i find the Camshaft torque sequence for a ford focus 2005 2.0

In the link, but not what you mean by 'High Feature'?

https://www.google.com/search?q=2011+GMC+3.0L+torque+sequence+for+camshaft+and+cylinder+heads

..

torque 22 Nm (224kgF-cm, 16ft,lbs}

9 5 1 3 7
-------------------------------- front of engine torque sequence
10 6 2 4 8

1. Tighten all bolts in a single sequence to 50 Nm
2. Back the bolts off 1/2 turn.
3. Tighten the bolts in sequence shown to 50 Nm .
4. Rotate all the bolts in a single sequence an additional180 degrees in two steps of 90 degrees each.

9 3 1 5 7
8 6 2 4 10 sequence for head


Spec for rod 38Nm

If all else fails, start at the center and use criss-cross pattern working from center out. Be sure if these are one time use bolts to replace them, and find correct torque specs from shop manual or dealer.

Stick all the bolts in and run them down snug. Start at the center bolt and torque it half spec. Then do the same with the rest in a circle from center to the outside. Then torque them to full spec from center to outside in a circle. This is normal procedure if the sequence is not available. You could always google it if you don't trust this old timers suggestion.

double posted, never double answered

Crankshaft Belt Pulley 85 ft.lb


Rear crankshaft oil seal carrier 15 ft.lb
Camshaft Timing Belt Pulleys 50 ft.lb

Camshaft timing belt pulleys 50 ft.lb

Same TIGHTENING Sequence for Single OHC

1. CAUTION: Always install new cylinder head bolts. NOTE: Lubricate the cylinder head bolts with Super Premium 5W 30 SAE X0-5W 30-QSP or equivalent meeting Ford specification WSS-M2C153-G prior to installation. Install the cylinder head assembly and tighten the cylinder head bolts in the following sequence.

1. Tighten all bolts in a single sequence to 50 Nm
2. Back the bolts off 1/2 turn.
3. Tighten the bolts in sequence shown to 50 Nm .
4. Rotate all the bolts in a single sequence an additional 180 degrees in two steps of 90 degrees each.

9 3 1 5 7
8 6 2 4 10 sequence for head


Spec for rod 38Nm

CAMSHAFT BEARING CAPS TORQUE TO 125 INCH POUNDS. CAMSHAFT SPROCKETS - 44 FT LBS. YOU NEED A REPAIR MANUAL LIKE A CHILTON WITH CAMSHAFT TORQUE SEQUENCE DIAGRAM. YOU HAVE 20 CAMSHAFT CAP BOLTS THAT HAVE TO BE TORQUE IN SEQUENCE.

looks like there is special sequence to reassemble and tightening, a quick note replace any bolts that have two punch marks.tighten as follows: x x x x x 10 4 2 6 8 x x x x x 7 5 1 3 9 torque all down to 15 ft lbs torque to 30 ft lbs plus 90 degrees. Good luck!