Bulb replacement for 2001 Chevy Blazer

Check the brake bulb socket for short , clean replace bulbs , check connector to rear licence plate lights . Also trailer harness for short , all on same fuse circuit .

Hi there,

There are two bulb containers above the license plate light and you just need a small screw driver to press in under the left side of the plastic bulb housing to release the plastic clip. The plastic bulb holder will swing from the right hand side and will then fall out. All you need is a medium size flat head screw driver.

You have to unscrew the housings with a philips screw driver and take the housing out of the hole, by turning it sideways and pulling it out. Then turn out the bulb holder from the back of the housing and pull out the bulb.

Hope this helps...

You need to pull the cover of the bulb off, There may be a clip it may need help from a screwdriver. Replace the bulb and replace the cover

You need to go under the rear bumper and you will see the connections.Just twist counter clockwise and it should come out.Hope this helps.Good luck.

kind of tricky, took me an hour to get it figured out, but you got to open the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together, im cant remember off hand the bulb size, but your local auto parts store will have that info when you go to buy them

LICENSE PLATE LAMP BULB
REMOVAL

1. Remove screws attaching license plate lamp to rear bumper
2. Remove lamp from bumper.
3. Remove bulb socket from lamp.
4. Pull bulb from socket.

INSTALLATION

1. Install bulb into socket.
2. Install bulb socket into lamp.
3. Place lamp in position.
4. Install screws attaching license plate lamp to rear bumper.

I'm assuming you mean the rear license plate bulb?

Depends on if you have a coupe, sedan, or wagon.

Here's a link to the owner's manual. Start on page 247 and use the procedure that's right for you Focus type:

http://www.motorcraftservice.com/pubs/content/~WO1FOC/~MUS~LEN/41/01focog4e.pdf

Take a thin blade screw driver and gently pry between the rubber seal and the metal and pop the light out, replaced the bulb and pop the light back in. works fine.

right above the plate the bulb should be.

They twist in and out from the back of bumper. Pull the bulb socket out of light fixture, twist out the bulb and install new ones.