My bssell is not putting out water. - Cars & Trucks

https://video.search.yahoo.com/search/video?fr=mcafee&p=1998+oldsmobile+intrigue+water+replacement+video&type=E210US1494G0#id=2&vid=31be44c276a1b2c75eac99254416f24b&action=click

This should help.

if ran it with ouut water / coolant for to long possible blew up engine --if water going out as fast as putting in --freeze out plug gone or damaged --head cracked --engine block cracked

Here's a link to replace your water pump.Here's how to replace thermostat,If your water pump is leaking,there will be antifreeze coming from it.

I have a 2002 vw beetel where do I check the water level at? It's seemed hot.. I just had water pump timing belts done New fan and thermostate put in..

Ur car is having a clogging water pump or a dying water pump problems.The car water pump it is not doing it job like circulation of the water in the car through out the car engine evenly.The car keep losing water that u keep putting it in because of the car engine keep overheating and causes water candensation and evaporation of the water u keep putting it into the car.This car must have be check out by an auto mechanic for changing it holes systems on the car water pump or must have be do a replacement of the whole water pump unit itself.

Well you must put the water in the radiator or deposit for water that your car has instead of the water pump, the water pump is an internal part bolted in the engine that has a pulley that makes circulate the water inside the engine.

Hello drain the water from the radiator by removing the hose from the radiator to the water pump,after having taken out the hoses,then unscrew the bolts that hold the water pump.After having taken the pump,clean the surface where the pump is fitted on the engine.Now when putting,the new pump,put a clear layer of silicone gasket on the surface where the pump will fit to prevent leakage,now you screw the bolt to the same torque,then after put the hose back like it was before,fill your radiator ,do not put the cap now,because of an air lock in the water circuit,start the engine,you will see the water level lower,fill it to its level,then put the radiator cap.Hope that help you in changing the pump,good luck

check fan motor

First of all, the normal water pressure is anywhere from 50 to 70 lbs. Why do you need a pump? What you need is just water pressure. The shower head will only put out a fraction of that pressure with the valve body inside the head. Since you do not say what water pressure you have, check all the pressure lines to make sure there is no blockage. As for the water tank, well, 50 gallons is always better.

buy a new water pump, remove the radiator, remove the hose from the pump, remove the bolts that holds the pump, remove the old pump.

put the new gasket in the pump, dont forget to put a little bit of grease just to hold the gasket inplace. put the new pump, use the old bolts from where they are taken ( sometimes they are not of equal length ). if you have a torque wrench then use it to tighten the bolts with equal amounts of torque. put the hose back, put the radiator back, put water in the radiator, run the engine and look for some leaks at the new pump.

i hope i did it..

tnx, drcool