Did you change any wiring , tap into any wiring ? There is no flasher relay on your vehicle . It controlled by the BCM !
Turn Signal/Hazard Lamps
The body control module (BCM) is responsible for controlling the turn signals and hazard lamps. When the turn signal switch is placed in either the left turn or right turn position, the BCM receives a signal from the turn signal switch. The BCM then sends an on-off voltage signal to either the left or right turn signals and their instrument panel cluster (IPC) indicator. When the hazard switch is pressed, the BCM receives a signal from the hazard switch. The BCM then will send an on-off voltage signal to all the turn signal lamps. All the turn signal lamps will flash including both IPC turn signal indicators.
Your best bet , take it to a qualified repair ! We on here have no clue what you did . On this newer vehicles ,if you know nothing about automotive electronics you really should take to a professional
SOURCE: 1997 Chevy Tahoe both turn signals stopped working
Sounds like the flasher unit to me. Normally the emergency flasher and turn signal are separate.
SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards
I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!
SOURCE: Where is the Hazard/Turn Signal switch located in
2000 Dodge Intrepid 2.7L SFI DOHC 6cyl
The Flasher is located
front seating area, driver side, under left hand side
of instrument panel between junction block and brake
pedal.
Testimonial: "Yes, this was ver helpful. Thank You! PS. If that photo is the Lady that answered my question, OMG!!!!!!!!!!!!!!"
SOURCE: turn signals and hazard don't work
On my 2005 Dodge Caravan the turn signals and wipers suddenly stopped working.
SOURCE: Turn signals and hazard flasher stopped working in
Yes, you are on the right track. More than likely it is a defective flasher relay as one relay controls turn signal and hazard flash. The flasher relay is located behind the left side of the instrument panel.
Testimonial: "clay58 is very knowledgeable. His advice was on the money. Thanks!"
1,136 views
Usually answered in minutes!
×