SOURCE: location of cam position senor
Not a bad job to replace the cam position sensor, it took about two hours cost about $150.00 with oem parts. First remove air filter box,remove plastic spark plug cover. Jack up engine about an inch remove engine mount. Now you can access sensor through a convenient cover that mounts around engine mount bracket extending from engine block.( one ten millimeter bolt) Remove accessory drive belt for a little extra room and replace with new one while you are in there. Just between the two cam gears you will see a torx screw that aligns the switch when in installed. DO NOT REMOVE THIS Just above the torx screw is a reverse torx screw (6 millimeter) Put a shop rag in the access hole to catch the screw just in case you drop it ,( so it does not fall into timing belt cover) Put something "sticky" in the 6 millimeter socket such as gasket sealer to keep from losing screw. remove. Pull switch up from inside spark plug cover and install new one through the same. reinstall 6 millimeter bolt. Switch is self aligning. Reinstall belt, engine mount, air box. Doing this myself probably saved me about $150.00 to $200.00 dollars
SOURCE: 1995 Windstar OBD II showing codes PO340, PO171, and PO174
Hello;
With those codes, the first place I would check is the fuel pressure. Also check the fuel filter and replace it if you haven't already. Then clear codes and recheck. Even if your fuel pressure is with in range it still may not push enough fuel to operate your vehicle.
SOURCE: Where is Neutral safty sensor switch located on Grand Cherokee
OK then the switch is part of the gear selector switch on the side of the trans where the shift linkage hooks up. here is a picture and part number.
ACDELCO Part # C2241 $233.89
SOURCE: camshaft position sensor failure on Saab 2003 93
replace it. there is a connection or a short in the sensor that's throwing the code. Get your Saab parts at Carquest Auto Parts, They have a WORLDPAC division for all hard to find(and easy) parts. trust me, you will save a fortune on Saab, Mercedes, Volvo and other high end parts.
SOURCE: Cam position sensor error.
It's not enough only rebuild yours engine !!!
After new camshaft position sensor instalation and timing perfectly alignment you must scan the engine control computer and erase these error, actually all errors stocked in memory. The best scantool is VAS device used by VW-Audi dealers, VAG-COM by RossTech (cable + software 704.014, 805.01, ... on CD), or also Bosch KTS 540, 570, 670, ...
RESET = erase errors from the engine control computer memory !
Yours engine control computer don't understand if you only replace damaged sensors with new others! Errors still remains in memory affect engine runing!
Best regards!
1,252 views
Usually answered in minutes!
×