As soon as I get motor started, it floods its self out..has a new fuel pump on it.has anyone else had this problem before. Jim in Phoenix, az

SOURCE: installed new fuel pump still not start

I would definately say start by looking at the fuel cutoff switch in the trunk. There should be a red button you push in and it should start workin again

SOURCE: 750 holly carb put a holly fuel pump floods won't

sounds like the float is set to low and its not shutting fuel off . take the fuel bolws off . check the distance of the float. if the float adjuster is set all the way to the bottom . it wont shut off check it turning it upside down . close off fuel line and blow threw shut off valve if its not closed , take the float out clean it and adjust the tab in the back so it hit the shut off the fuel inlet valve sooner ....dont adjust it to high it will cause u to run out of fuel so go to your holllie rebuild kit for spec

SOURCE: i have fuel but flooding truck i have changed fuel pump ,relay,everything to do with fuel still floods out

Have the cpu read for fault code.Have a manifold pressure and pump pressure test done. Check oxygen sensor for operation

SOURCE: How ling does it take to get a letter from Phoenix

3 days.

SOURCE: 93 mazda mpv starts like its flooded then clears up runs great. then acts up periodicly when passing or restarting. it has been tuned up new fuel pump good gas

Possible engine coolant temp sensor telling ecu it's -40 so it's putting to much fuel in