Use this app on your cellphone (android) Downloading Oil Light Reset Pro v1 5 apkpure com apk 9 4 MB
SOURCE: service engine soon light on a 2000 cadillac seville
The service engine soon light indicates you have a problem with the engine management system.The only way to get it to stay off is to lacate and repair whatever is not working correctly. Requires very specialized equipment. Take it to your mechanic.
SOURCE: Replace tail lights
Usually all you have to do is pull back the inside trunk liner behind the tail lights from inside the trunk, or there may be a plastic door that you open to access the tail lights. The wires going to the tail lights connect to a plug that you turn counter clockwise and pull out from the back of the tail light assembly. Once you have removed the connector replace the bulb. Some light bulbs just pull straight out of the connector, others you may have to push in and turn counter clockwise to remove.
SOURCE: low oil pressure, stop car on 2001 cadillac seville
HI. this could be a faulty sensor or a bad oil pump screen as well. the oil pump malfunction is the worst scenario in this case. You can actually test the sensor with a voltage needle to see if its getting the proper voltage. i would inspect the wires that are attached to the sensor as well. if the wires are good and the current level is ok as well, it will most likely be a faulty oil pump or bad oil pump screen as well.
In this case, i would recommend inspecting the oil pump assembly. here is a inspection guide below that will help you confirm oil pump failure.
--OIL PUMP INSPECTION GUIDE--
The internal parts of the oil pump are not serviced separately. If wear or damage is noted, replace the entire pump assembly.
Please rate and have a great day:)
SOURCE: Need to replace both crankshaft position sensors 2001 Cadillac
4.6 the twocrankshaft position sensors are located on the front of the block just above and to the left of the oil filter. not hard to replace.
SOURCE: abs light/traction control light
You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.
128 views
Usually answered in minutes!
×