SOURCE: replace serpentine belt on 2004 dodge caravan
Hello
Here is a link for belt replacement
RD
http://www.autozone.com/addVehicleId,2945902/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c152800b639e
SOURCE: Belt Tensioner replacement
A simple bolt on assembly, the tensioner for the serpentine belt may need replacement if it fails to smoothly pivot and maintain tension on the belt.
Using a half inch breaker bar, release tension by rotating against the spring, remove the belt from the tensioner. Unbolt the tensioner (one bolt may be so diffucult to reach that you might want to use a racheting open end wrench by Alden.
Install the new tensioner by reversing these steps.
I usually replace the belt at the same time.
SOURCE: serpentine belt diagram for a 3,3l dodge dynasty
For the 1991
DODGE DYNASTY - V6 3.3L 201ci GAS FI N R , review this informacion:
Belt Routing Diagram
- Multiple Accessory, w/o A.C. (Mfg. After 2/27/91)
- Multiple Accessory, w/A.C. (Mfg. After 2/27/91)
- Multiple Accessory, w/o A.C. (Mfg. Before 2/27/91)
- Multiple Accessory, w/A.C. (Mfg. Before 2/27/91)
Remove the serpentine belt by using a breakover bar, rachet or serpentine belt removal tool with the correct size socket for the pulley mounting bolt. Rotate tensioner arm to release tension. Remove the belt.
Hope helped with this (remember rated this help) Good luck.
SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan
3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!
SOURCE: Where is the shift solenoid located in my 98 Dodge
THE SOLENOIDS ARE INSIDE THE TRANSMISSION, U MUST REMOVE THE SHEET METAL TRANS PAN TO SERVICE THEM.
47 views
Usually answered in minutes!
×