2004 g35. No power to one rh low beam headlight and both side markers

SOURCE: low beam headlight on Pilot 2004

Hi again,

I lookd for the Technical Service Bulletin on headlights that you referred to in our Live Chat. It is Service Bulletin 07-027 dated May 12, 2007. A downloadable copy is avaibale here. It contains procedures, photos and images on how to address the issue. However, may I point out that said TSB refers to both left & right low beams and not only the right.

Hope this be of additional help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

SOURCE: burned out headlight/bulb bmw 1991 325i 2dr

It's a bulb replacement. If it's anything similar to my Audi, there is a cover on the back of the headlight housing that you pop off. Then you can reach in, pull the wire connector off the bulb, and unclip a metal retainer over the bulb, and pull the bulb out. Installation of the new one is the reverse. Just be SURE not to touch the glass part of the bulb. Skin oils can cause a halogen bulb to burn very hot and burn out very quickly. If you do touch the glass, wipe it gently but thoroughly on a cotton cloth to clean it off before you install it.

SOURCE: low beam headlights not working on 2004 Pontiac Montana extended

You headlight lamp have a diffuser mechanism which allows it to flip between the hight beam and low beam feature of the bulb. In fact, you high beam will function even if the low beam is not working.

I would recommend the purchase of the new headlight lamp. It would cost you you any where from $15.00 per unit to get a replacement lamp

SOURCE: how to change front driver side 2004 g35 coupe marker light

Just pop out the side marker from where the marker meets the fender well and push outward on the side marker. It has a metal clip retaining it to the bumper.

This entry was in January, most likely you figured it out already.

SOURCE: I Have an Audi a4 Quatro 2004 model. Adjust Low Beams?

There are two adjustment points (screws). For example left headlight: you will see one point near the end of left wing, at bottom side through a wing hole. This is for vertical plane headlight beam adjustment (up-down). Another one point is against water radiator side. This is for horizontal plane headlight beam adjustment (left-right).