Can't charge wrong port adaptor fits only one port. The smoke and smell is because of the overfill. To much pressure in the system. How much did you over charge? Might be able to help get it back to correct charge
SOURCE: No a/c, no freon....2001 dodge ram 2500 diesel 2 wheel drive
It is most likely the evaporator leaking. You'll need to remove the dash panel assembly and the heater housing to gain access. I have replace many Chrysler evaporators in trucks, minivans, and Jeeps to name a few. I hope this helps.
SOURCE: I'm looking for the port to recharge the AC 2006
Look for the larger A/C line that goes to your A/C compressor,you will find a port on it thats the one you use.
SOURCE: A/C compressor pulley is seized and burning the serpentine belt
yeah its seized up[ and they dont make a repair kit for that one either. they have at most auto parts stores an ac bypass pulley . its a bracket and pulley so you can bypass the factory ac unit and still run the factory belt. but if you decide to change the ac unit there are 5 bolts holding the unit down .have the system evacuated.loosen belt and drop down out of your way. take the ac lines off the compressor and set aside . there are two bolts on top in front and there are 3 bolts in back on top tieing together a triangle shape mounting plate , take all 5 loose and out.disconnect ac wires (snap clip) lift , lightly pry off old ac unit.set aside and reverse the procedure to install your new or salvage yard ac unit. refrigerant chargers can be purchased from wall mart ( there cheaper) at $30. roughly 2 1/2 cans will completely fill the system just follow on label instructions. its all easy to do if you can use wrenches and have a little knowledge. and you get the satisfaction of doing it yourself. and save a bunch of $ along the way.
SOURCE: 2001 Dodge Ram 2500 - gauges don't work
check the engine to body ground strap. located rear top of engine screwed to firewall Remove,clean, and resecure.
102 views
Usually answered in minutes!
×