2000 Nissan Pathfinder Logo
Sokphy Leak Posted on May 20, 2015

Replaced damage abs sensor. How do you reset the abs light on a 2000 nissan pathfinder LE?

1 Answer

jeepaholic326

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

New Friend:

An expert that has 1 follower.

  • Contributor 10 Answers
  • Posted on May 20, 2015
jeepaholic326
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

New Friend:

An expert that has 1 follower.

Joined: May 19, 2015
Answers
10
Questions
0
Helped
3007
Points
33

You will need to clear the codes with an OBD-II scanner, or remove the negative battery cable from the battery for a few minutes. Just be sure the ignition switch is off when disconnecting/reconnecting the battery cable. Have a good one.

5 Related Answers

Anonymous

  • 160 Answers
  • Posted on Jan 03, 2009

SOURCE: 2003 ford sport trac --- abs sensor light on

its is the abs comp

Ad

klgr_trout

  • 12 Answers
  • Posted on May 02, 2009

SOURCE: my 95 nissan pathfinder has "ABS" and "BRAKE" lights on my dashboard..how do i get rid of these?

Take it to a shop before you have a wreck because your brakes failed.

Anonymous

  • 63 Answers
  • Posted on Jun 02, 2009

SOURCE: code P0500 kicks on even after reset

Speed sensor malfunction (Speed Sensor A)
Remove and replace.

kevingsuzuki

  • 752 Answers
  • Posted on Feb 21, 2010

SOURCE: changed battery on 05 nissan pathfinder. vdc

try and disconnect the pos battery cable for a bout 10 minutes and see if this resets it make sure you have radio code in case ur radio locks

Anonymous

  • 1 Answer
  • Posted on Nov 20, 2010

SOURCE: ABS FAULT WITH NISSAN TERRANO YREG

Had same fault - was damaged wiring in loom at back of engine where main engine harness meets the bulkhead.

There is a screened cable grey/pink that houses the two O/S/F ABS wires blue and pink. The loom copex cuts through the ABS cable causing this fault. Take a look at link below:

http://www.bba-reman.com/forums/Topic79424-1-1.aspx

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

98 nissan pathfinder v-6 automatic le ,Cleaned plintum and mass air flow sensor ,,Drove to gas station went to leave and RPMs started to pulse down and back up At 2000 rpms ?...?

What did you use to clean the MAF? Most cleaners for throttle bodies and carburetors will damage the MAF. You must use cleaner specifically designed for MAFs to ensure that they will not be damaged during cleaning.
0helpful
1answer

Nissan pathfinder deisel 2007 slows down between 100-120km while foot flat - ABS and (!) light on

The exclamation mark is not something you should ignore. The whole thing could be caused by the ABS light because stability control is limited now because of the ABS. That would cause power to be limited also. Get the engine dignosed for free at any autoparts store that is a large chain store.
1helpful
1answer

New tires and alignment on 2005 pathfinder now vdc slip and abs lights are on

Sounds like a failed/damaged wheel speed sensor problem to me.
0helpful
1answer

2001 pathfinder LE code 1320 won't clear

DTC Confirmation Test Malfunction is detected when ECM does not receive signal from ignition primary circuit during engine cranking or running. Possible causes are:
  • Ignition primary circuit open or shorted.
  • Defective power transistor (integral with ignition coil).
  • Defective condenser.
  • Defective Crankshaft Position (CKP) sensor (REF).
  • CKP sensor (REF) circuit open or shorted.
1helpful
1answer

ABS and emergency brake light on

try bleeding the system and if you went 4x4ing you may have knocked off a wheel sensor.
0helpful
1answer

ABS FAULT WITH NISSAN TERRANO YREG

Had same fault - was damaged wiring in loom at back of engine where main engine harness meets the bulkhead.

There is a screened cable grey/pink that houses the two O/S/F ABS wires blue and pink. The loom copex cuts through the ABS cable causing this fault. Take a look at link below:

http://www.bba-reman.com/forums/Topic79424-1-1.aspx
3helpful
1answer

Code P0500 kicks on even after reset

Speed sensor malfunction (Speed Sensor A)
Remove and replace.
1helpful
1answer

01 nissan pathfinder

The mass airflow can get dirty and you will get trouble codes for everything under the hood except for the mass airflow. Try unplugging your mass airflow and driving the vehicle, if your problem goes away you need to clean the sensor. Buy some mass airflow cleaner though because other cleaners can damage the coating on the sensor.
0helpful
1answer

Oxygen sensors 2000 Nissan Pathfinder

are you sure it white smoke and not black smoke?
Not finding what you are looking for?

453 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...