Why does the battery keep overcharging on my 1984 Chevy S10?

Try this site www.alldatadiy.com

Got an 84 shop manual with wiring

What do you need ?

Also got a 1984 S10 Blazer since new

1984 Chevrolet Truck S10 P/U 4WD 2.8L 2BL 6cyl the Fuel Filter is located under hood, center, upper engine area, front of carburetor, mounted in fuel line.

First, release the fuel pressure by opening the fuel filler door. Then you replace it by squeezing the quick release plastic clip on the front and sliding the fuel line forward; you then use a wrench to loosen the nut on the back. Be prepared for some gas spillage with a container or some old rags. Once it is loosened, you remove it from its bracket, replace it, hook it back up (reverse of what you did) and it should be good to go.

Good luck.

remove the transmission,remove the converter,and use a screw driver,and pry the seal out,then just tap the new seal in with a block of wood.

if your pressure is too low this fix is quite expensive and not worth for older cars, so the first thing you should try to keep it running is to use THICKER OIL (W20-50 or such), + oil stabilizier (any good oil additive). I tried it in my Jeep,- helped right away.. Good luck

look under instrument panel to the left of the steering column,

G

I don't believe you need to weld anything, but its a good idea to have a torch maybe, to get off the old one. or a big hammer.

sounds like u may have a bad ignition coil or pick up modual

.045

at the arm remove the cap on end and their is a nut remove it 10 mm / Please rate my response thank you very much