?€¢
The ambient light sensor indicates daylight.
?€¢
The vehicle is not in the PARK position.
When the above conditions are met, the lamp control module (LCM) supplies battery positive voltage (B+) to the low beam headlamps through CKT 589 (GRY), the DRL resistor, and CKT 12 (TAN). The DRL resistor reduces the voltage supplied by the LCM. The low beam headlamps light at a reduced intensity. The DRL disable if the vehicle is placed in the PARK position. When the ambient light sensor indicates darkness, the low beam headlamps automatically switch from a reduced intensity to a regular intensity.
Lamp Control Module (LCM)
In the center of the IP, below the center heater outlets
Step
Action
Value(s)
Yes
No
DEFINITION: This diagnostic procedure should only be used if the high beam headlamps are operating properly and the low beams are inoperative.
1
Did you perform the Headlights System Check?
--
Go to Step 2
Go to Headlight System Check
2
Does the test lamp light?
--
Go to Step 3
Go to Step 5
3
Does the test lamp light?
--
Go to Step 4
Go to Step 6
4
Does the test lamp light?
--
Go to Step 7
Go to Step 8
5
Replace the headlamp dimmer switch.
Is the repair complete?
--
Go to Headlight System Check
--
6
Repair the open in CKT 359 (PPL) between the headlamp dimmer switch and the daytime running lamp relay.
Is the repair complete?
--
Go to Headlight System Check
--
7
Replace the high/low beam headlamps.
Is the repair complete?
--
Go to Headlight System Check
--
8
Is the repair complete?
--
Go to Headlight System Check
--
23 views
Usually answered in minutes!
×