How do i run an idle releArn process. On a 2006 hyundai accent

torque hyundai accent Questions & Answers - Fixya

www.fixya.com > Forum > Tags

Torque specifications for cylinder head 2000 hyundai accent Are you aware that ... cover gasket on my 1997 Hyundai Accent GLS (engine code G4EH, 1.3L).

Hyundai Alpha engine - Wikipedia, the free encyclopedia

https://en.wikipedia.org/wiki/Hyundai_Alpha_engine

WikipediaG4EH in a 1999 Hyundai Accent L ... lb·ft (132 N·m) at 4000 rpm, although some websites quote the torque rating as being 97 lb·ft (132 N·m) at 2700 rpm. ... 1992 Hyundai S-Coup? LS specifications - Carfolio.com · 1992 Hyundai S-Coup? GT ...

[PDF]AERA Torque Specs

www.aera.org/uploads/4/3/7/7/43776611/aera-torquespecs.pdf
AERA Torque Specs. 500 Coventry Lane, Suite 180, Crystal Lake, IL 60014. Toll-free Technical Hotline: 1-888-324-2372 (1-88-TECH-AERA). 815-526-7600 fax ...

.

Torque Specifications - AutoZone

www.autozone.com/.../Hyundai.../Specifications/Torque-Speci...

AutoZoneTorque Specifications. Print. Specific to: Hyundai ... Specific to: Hyundai Accent2006. Hyundai Azera 2006. Hyundai Elantra 2006. Hyundai Sonata 2006.

Club Accent Qu?bec • Consulter le sujet - hyundai motor s

I would suggest a compression test to ensure that all the damaged valves were replaced. Replace the MAF sensor as it appears that it is faulty

it could be your transmisssion is not reading in park pos. have you looked at that.

a the dealer or parts store

so what do you mean you.did it with.a.scanner ? you have a SNAP On scanner ? or you talking about a scan took, that reads codes and will clear.codes ? if this is what you used, then all you did was clear the code, you did no programming, relearning, nothing ! Then.take both.battery cables off the.battery, then.touch.them.together for about 30 seconds, this d energizes.the system, then place the neg.and the pos back in the battery start your car, hold your RPM around 1500 for about 2 minutes, then.go.drive your car to get to.the speed of 40 and drive it for more then 20 minutes, this way your warming it up and relearning everything

Have the fault codes read Replace the faulty units with genuine one because most aftermarket units are not set
for OEM cpu units and are not completely compatible

Engine check light is activated by the oxygen sensor, have the sensors reset with scanner, if the light kicks back on, then have sensor checked and replaced if necessary.

has it been driven too many kilometers ?
This should not happen at this age (2006) if not driven too much. If it is under manufacturers warranty then dont wait and take it to the service center as this could happen due to the oil burn within the engine. Atleast not at idle.

the tps (throttle position sensor) could be causing the problem

Hyundai has a TSB for this: 07-40-010 - AUTOMATIC TRANSAXLE HARSH AND/OR DELAYED
UPSHIFT OR DOWNSHIFT". This one will also refer to TSB# 06-40-005 - AUTOMATIC TRANSAXLE CONTROL MODULE -RESET AND RELEARN ADAPTIVE VALUES. either need to be performed by the dealer.