My remote car stater does not start my car when i push the botton it beeps but nothing happens

Should be bottom middle

Thats and example i dont no your model of car

I don't understand what you are trying to say. If the key turns all the way to start and nothing happens, you probably have an ignition switch failure

are you sure the battery in remote is not bad?? first thing to check

use remote to disable the alarm or close drivers door turn key in door lock lock and unlock car 3-5 times if you do not have an alarm remote to said car this will disable the alarm system

Most manuals are available on-line Through the Manufacture. My personal experience with remote starters is you hold down on the button for until it stops blinking. However that is only one brand and very well may be different from yours.

2001 vw bora 1.6 key wont open boot working lock ok. lift pad nothing happens ,no power at multi plug to activate cylinder ,what could be the fault

that is because the push button pad is broken inside the remote box unit or either it is not making contact with the switch in the alarm remote. may need to replace the push button remote box.

NEED TO REPLACE STARTER.

Try holding the hand held remote up next to the homelink (built in remote). Hold down the botton on the hand held remote and the botton you want to program in the car at the same time until the homelink light goes out. This could take 60 seconds or more. Now depending on which model garage door open and how old it is you may need to program the car to the opener. Usually this is done by pushing the botton on the back(Liftmaster,Sears, Chamberlin) or the botton on the front(Genie) and then go to the car and push the same botton on more time. I hope this helps.