Reconnected battery. Dashboard lights and engine checking sequence worked. Followed Audi Manual instructions (key in position 2 for 5 seconds). Turn ignition and nothing happens.
SOURCE: Engine has miss-fire
First check spark plugs/wires/distributor cap (tune up). Also would be good idea to use fuel injector cleane and change fuel filter and O2 sensor.
Hope that helps
Good Luck
Timing belt might have broke. Same thing happened to mine. Going to cost ALOT of money to fix.
SOURCE: audi tt 180, 2000 imobiliser problem
I have the same problem. Short term answer for me is to disconnect battery for 30 seconds and then the car will start. I have the infamous dashpod problem and the keys and eveything are coded into the dashpod so I'm hoping when I get mne replaced the immobilser problem will go to,at least the guys who work on my car reckon so.
With the regular need to disconnect he battery I leave the three screws for the battery cover finger tight and the battery contact loose enough to wriggle off. I can do it start to finish in a couple of minutes but is a mjor pain still.
SOURCE: windshield wipers dont work 2001 audi tt
most likely the wiper signal arm itself if you have tilt wheel over time the wires stretch wear and break causing a short otherwise have a test light handy and with the wipers on position check for power at the wiper ,motor if none is present its the switch if it is present its the motor
SOURCE: car wont start after getting a new key and replacing batteries -
hi well this is a bit long so if you can bare with me i will try explain how to , clear system to decode, and recode as this is what it sounds like that the coding has gone from the ignition key....ok here goe's
to sync key with car
depress lock or unlock button
manually lock the drivers door within 30 seconds of the above
system should now work....if not do next bit
switch ignition on ( using non chip key )
manually lock drivers door using key ( another one, hopefully you will have more than one)
press unlock button 5 times, in one second intervals
indicators flash 5x for every time signal is received
switch ignition off and remove key
that's the de-programming done...
to de-program the system if above fails..........
switch ignition on ( use key without remote )
manually lock drivers door using key to be synced with car
complete the following within 30 seconds of doing above
within 5 seconds press the unlock button on key
indicators should flash once
wait 5 seconds
press unlock button once to confirm programming
vehicle should unlock
this also will confirm deactivation of programming mode
switch ignition off remove key..that should be it, then try new programed key in ignition.
to re-program system and sync with key
switch ignition on
manually lock drivers door using key ( another one, hopefully you will have more than one)
press unlock button 5 times, in one second intervals
indicators flash 5x for every time signal is received
switch ignition off and remove key
that should be it, if no joy then will have to main dealer i am afraid...hope this helps
403 views
Usually answered in minutes!
×