The fan motor or wiring might be at fault , loose connection.
even the fuse panel too.
SOURCE: Check Air Suspension for 2000 Mercury Grand Marquis
It sounds to me like your compressor got killed. What probably happened is that the airbag got a hole or tiny crack in it so the compressor has to work extra hard because it is like blowing up a balloon with a hole in it. Therefor the airbag killed the compressor. I would recommend going to strutmasters.com and taking a look at our conversion kits. these convert you from the airbag to a powder coated American made steel coil spring that is guaranteed to last the life of the car. I added the link below so you can check it out.
http://www.strutmasters.com/mercury-suspension-parts-s/25.htm
I hope I was of some help
Good Luck!!!
SOURCE: mercury 2003 gand marquis heater
One of 2 things could be happening. #1, the valve that allows coolant to circulate thru the heater core is not functioning. #2 the door that is actuated to allow cabin air to circulate around the heater core is not functioning properly. Possible causes, linkage to the valve, or actuator not working. Also a broken valve to the heater core. A vacuum leak, or faulty actuator would cause the door not to function. You can narrow down the problem somewhat by making sure that both heater hoses have hot coolant in them. You can do this by simply feeling the hoses. If they are both circulating hot coolant, then the problem is the misdirection of air flow. To repair this, the cause will have to be diagnosed, could be anything from your dash mounted controls to an issue with vacuum or the ductwork or the door or actuator. If not in the controls, the dash may have to come out. Good Luck, I hope this is helpful!
Testimonial: "thank you it is clear we will do the daIGNOSTIC "
SOURCE: 2003 mercury grand marquis LS
The blend door is stuck in cold position. That usually happens because the blend door actuator has failed.
You will need to test and replace the blend door actuator.
To replace the actuator you will need to take apart the dash and remove completely the instrument panel,d isconnect the connector, remove the four screws, remove the temperature blend door actuator and replace it.
The replacement is not a job for beginners, since you have to take apart the dash to access the actuator.
Regards.
SOURCE: Heater in mercury marquis doesn't come on. Cold
Hello. The most common cause for no heat is the thermostat. This is a quick and easy repair. Go to any autozone or similar parts store for the part. They may even install it for you.
117 views
Usually answered in minutes!
×